Post by robby anderson on Sept 17, 2005 9:35:12 GMT -5
ok here is how to port your feedneck so you dont get blow back and chop balls, a mod so ur hopper doesnt wobble.
NOTE:these mods are for tippmann 98's only same with the trigger mods.
porting your feedneck-this is a simple and very cheap mod
supplie:drill and bit make sure the bit isnt to big and fine sandpaper
just drill holes in ur feedneck and do any patern you prefer dont dont make to many holes and be careful were you place them so water or debri doesnt get into the feedneck.then wen done drilling take some very fine sandpaper and sand down the holes on the inside so the paintballs dont chop on the plastic sticking out.
no hopper wobble-this is the esiest mod there is.
supplies:o-ring
take off the feedneck and slip on the o-ring and that should stop your hopper from wobbling.
NOTE:these mods are for tippmann 98's only same with the trigger mods.
porting your feedneck-this is a simple and very cheap mod
supplie:drill and bit make sure the bit isnt to big and fine sandpaper
just drill holes in ur feedneck and do any patern you prefer dont dont make to many holes and be careful were you place them so water or debri doesnt get into the feedneck.then wen done drilling take some very fine sandpaper and sand down the holes on the inside so the paintballs dont chop on the plastic sticking out.
no hopper wobble-this is the esiest mod there is.
supplies:o-ring
take off the feedneck and slip on the o-ring and that should stop your hopper from wobbling.
